WSL will detect the existence of these files, read the contents, and automatically apply the configuration settings every time you launch WSL. The directory path should look something like: C:\Users\\.wslconfig. To get to your %UserProfile% directory, in PowerShell, use cd ~ to access your home directory (which is typically your user profile, C:\Users\) or you can open Windows File Explorer and enter %UserProfile% in the address bar.Distributions running as WSL 1 will not be affected by this configuration as they are not running as a virtual machine. Can be used only for distributions run by WSL 2. Used to configure settings globally across all installed Linux distributions running as the WSL 2 version.Stored in your %UserProfile% directory.The directory path should look something like: /etc/wsl.conf. To get to the /etc directory for an installed distribution, use the distribution's command line with cd / to access the root directory, then ls to list files or explorer.exe.Can be used for distributions run by either version, WSL 1 or WSL 2.Settings configured in this file will only be applied to the specific Linux distribution that contains the directory where this file is stored. Used to configure settings on a per-distribution basis.Stored in the /etc directory of the distribution as a unix file. WSL 2 runs as a lightweight virtual machine (VM), so uses virtualization settings that allow you to control the amount of memory or processors used (which may be familiar if you use Hyper-V or VirtualBox). The version of WSL that you are running will impact the configuration settings.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |